The Grating Clip fastener is a cost effective method of securing steel grating to existing structural steel members. Clamping the grating eliminates costly and time consuming welding and drilling. Access below the grating is not required, resulting in a quick and simple installation.
The Grating Clip fastener can be installed with a screwdriver and can be easily removed allowing the grating to be repositioned or removed for maintenance purposes. The Grating Clip fastener will suit grating bar widths from 1-3/16” to 1-5/8” and grating bar depths up to 2” to ensure that most standard grating sections can be accommodated. This product is supplied with a galvanized finish.
Product Code Material / Finish Screw Diameter Flange Thickness (T) Grating Bar Depth Grating Bar Spacing Max. GRAT 1G08 Pressed Steel / Hot Dip Galv.
1/8" - 3/4" 2-1/4" minus Flg Thk 1-3/16" - 1-5/8"
Step 1: Lower the Gratefix thrugh the open part of the grating, ensure the bracket is seated over the adjacent bearing bars. Step 2: Slide the Gratefix towards the supporting steelwork flange as far as it will go to ensure maximum clamping force. Step 3: Tighten the screw and ensure that the lower casting rotates until one of the steps locates on the bearing bar.
- Ask A Question